How to avoid falling off of tiles after pasting

2022-07-22
  • Detail

Due to the problems of ceramic tile quality or construction technology, many people find that ceramic tiles will fall off to varying degrees after decoration. It has caused a lot of inconvenience to life. In fact, it is also very easy to avoid these problems. As long as the following steps are done well,

due to the quality of tiles or construction technology, many people find that tiles will fall off to varying degrees after decoration. It has caused a lot of inconvenience to life. In fact, it is also very easy to avoid these problems. As long as we do the following steps well, we must keep in mind and reduce decoration problems

Smick ceramic tile Xinghui ceramic

pave the floor tile first

pave the floor tile without cement on the ground, after flattening, coat the floor tile with cement slurry, pave it on the ground, and the diagonal positions of the four bricks are flush. The laying sequence is also exquisite. The floor tiles should be pasted from inside to outside. If there is a slope or floor drain on the ground, pay attention to slope making according to the drainage direction; The wall tiles should be paved from bottom to top. For the sake of beauty, the tiles at the bottom should be pasted later. Press the floor tiles after the wall tiles are pasted. In addition, one wall cannot be pasted to the top at one time to prevent the tile from collapsing due to its heavy self weight. Don't step on the floor tiles in a short time after paving

ceramic tiles should be soaked as much as possible

in summer, because the materials are more dry than usual, for floor tiles, ceramic tiles and other materials that need to be soaked in water, the soaking time should be extended to make their moisture close to saturation. In this way, there will be no water absorption from the cement due to the drying of ceramic tiles during bonding, which will lead to weak bonding with the cement, hollowing and falling off, which will bring you some unnecessary trouble

in order to cater to trendy consumers, some new process methods have appeared in the market, such as tile adhesive, colorful joint filler, joint paving, etc. Ceramic tile adhesive (also known as dry sticking method), ceramic tiles do not need to be soaked in advance, and the base surface does not need to be wet. As long as the basic conditions of pavement are good, the operation condition can be greatly improved

clean the base course surface before tiling

if there are decorations such as lime paste, emulsion paint and wallpaper on the wall, or there are dirt on the ground, be sure to clean it up, otherwise the cement mortar will not bond firmly with the base course; In addition, if there are cracks in the wall itself, it should be properly handled before tiling, so as to prevent the cracks in the basic structure from becoming larger in the future, resulting in the cracking or falling off of the wall tiles; In addition, the ground and wall surface with too large difference in flatness or verticality should be leveled with cement mortar. Compare the color difference of tiles before paving

wall tiles should be fully soaked

because wall tiles have a high moisture content, this characteristic must be taken into account when pasting. Before tiling, the base course should be fully watered and wetted, otherwise, the moisture in the mortar will be quickly absorbed by the dry base course and tiles and set quickly, which will affect its bonding fastness. Otherwise, the wall tiles will absorb water from the cement, making the cement unable to act as an adhesive

link: low price trap lures you into decoration avoidance “ Fishing &rdquo

郑州牛皮癣医院

苏州皮肤病医院

西安妇科医院

Copyright © 2011 JIN SHI